How To Videos

Chalk Pastel

 

How To Resin Chalk Pastel


  1. Complete a chalk pastel design on paper sized to fit a wood panel (or other sturdy substrate).

  2. Brush adhesive onto the panel.

  3. Starting by lining up the side closest to you, carefully lay down the print onto the panel. Lay a clean piece of paper cut to size on top of the artwork.

  4. Using your hands or a brayer, gently smooth out the entire surface to remove air bubbles trapped under the paper and to ensure a good, secure bond to the panel.

  5. 💡A NOTE ON SEALANTS: If there is quite a lot of chalk dust that might float away in the resin or you’ve used uncoated paper that may absorb the resin, apply a spray sealant to your work before you resin. Choose a spray sealant that dries clear, offers UV protection and is appropriate for chalk pastel art. Allow to dry according to label directions.

  6. Wearing gloves, measure and mix the ArtResin according to instructions.
    💡TIP: Not sure how much resin you need? Check out our Resin Calculator.

  7. Pour the resin in the center of your artwork and use a flat-edged spreading tool to guide the resin over the entire surface.

  8. Use an Artist’s Torch to remove bubbles.

  9. Cover and all the resin to cure. After 24 hours, the resin will be dry to the touch and will be fully cured after 72 hours.


Read our blog How To Resin Chalk for full, step-by-step instructions!



ArtResin:  Made For Artists, By Artists.

See More Videos
See more videos