While it is extremely important to make sure that you stir your resin and hardener mixture for 3 minutes, you really can’t overstir epoxy resin. If you stirred for 10, 12 ,15 minutes, it’s not going to do any harm. Just remember that you have a 45 minute window in which you need to pour before the resin will start to cure and become too thick to work with.
So when you stir, make sure you go slowly, methodically, and make sure that you scrape the sides and the bottom as you go. Try not to get in there and really whip the resin because that will just induce more bubbles than you need. If you do have a ton of bubbles in the end, you can simply torch them out with our Artist's Torch.
Remember, though, it’s always better to have more bubbles than less bubbles because that means that you did stir properly.
Do you want to learn more about troubleshooting epoxy resin? Read our guides below:
- ArtResin’s Troubleshooting Guide
- Tips To Prevent Bubbles
- Can I Fix Small Imperefection In My Resin?
- How Do I Remove Epoxy Resin Drips?
- Is It Possible To Over Torch My ArtResin?
- Epoxy Resin Non Hardening
- How To Prevent Bendy Resin
- How To Fix Soft, Sticky Spots In My Resin?
- How Can I Avoid Getting Dimples In My Epoxy Resin?
- How Do I Get Bubbles Out Of Epoxy Resin?
- How To Reduce Dust Before Your Resin?
- How Can I Get Rid Of Bubbles In My Cured Resin?
- How Can I Fix Dust In My Epoxy Resin?
- How Can I Deal With Epoxy Resin Drips After They've Dried?
- What Happens If I Overtorch Resin?
- Why Does My Resin Look Milky?
- Why Is My Epoxy Resin Still Sticky?
- Why Is My Resin Bendy?
- Why Are There Bare Spots In My Cured Resin?
- What Does Silicone Do To Resin?
ArtResin: Made For Artists, By Artists.
