How To Videos

Flowers

 

How To Resin Flowers

  1. Assemble your flower petals and dry them, either by pressing them in a book, embedding them in silica gel or by using a microwave flower press.
    💡TIP: Ensure flowers are completely dried before you resin them. Remaining moisture will cause them to release bubbles and eventually decompose once covered in resin. 

  2. Create your design by mounting the dried petals to the substrate. Either pencil out your design or take a freehand approach. Coat the substrate with a slow-drying adhesive like ModPodge. Using tweezers, carefully apply the petals, one by one.  Allow the adhesive time to dry according to the label instructions.

  3. Seal your floral art with a clear drying spray sealant or a brush on sealant. If using a brush-on sealant, thin it out with a little water first to make it easier to apply. Allow the sealant to dry according to the label directions.

  4. Wearing gloves, measure and mix the ArtResin according to instructions. 
    💡TIP: If you're not sure how much ArtResin you need, enter the dimensions of your piece into our Resin Calculator.

  5. Pour the resin into the center of the artwork and, using a flat-edged spreading tool, gently guide the resin over the entire surface.

  6. Use an Artist’s Torch to remove bubbles.

  7. Cover and allow the resin to cure. After 24 hours, the resin will be dry to the touch and will be fully cured after 72 hours.


Read our blog How To Resin Flowers for full step-by-step instructions!


ArtResin:  Made For Artists, By Artists.

See More Videos
See more videos